Surgical masks UNE-EN14683:2019+AC triple layer (pack of 50 masks)

DESCRIPTION

Surgical Mask Packs - 50 units.

Rectangular mask with pleats, made of non-woven fabric, three layers, resistant to fluids. Anatomical adjustment to different sizes and facial characteristics, with moldable strip on the upper edge

Our masks meet the requirements of the UNE-EN14683:2019+AC standard. Our triple layer along with our TNT filter provides 95% filtration of germs and dust. It has joint ultrasonic welding, firm and safe.

Strong Filtering|Safe Breathing.

It does not release particles and is resistant to the humidity of the respiratory air flow.

Free of latex, fiberglass and toxic or irritating substances.

The middle layer with a bacterial filtration efficiency greater than 95%.

Fastening system with elastic bands.

CHARACTERISTICS

• It does not release particles and is resistant to the humidity of the respiratory air flow.
• Free of latex, fiberglass and toxic or irritating substances.
• The middle layer with a bacterial filtration efficiency greater than 95%.
• Fastening system with extra long and resistant straps.
• Rectangular mask with pleats, non-woven fabric, three layers, fluid resistant
• Anatomical adjustment to different sizes and facial characteristics, with moldable strip on the upper edge.
• Fastening system with extra long and resistant straps.
• The middle layer with a bacterial filtration efficiency greater than 95%.
• Free of latex, fiberglass and toxic or irritating substances
• It does not release particles and is resistant to the humidity of the respiratory air flow.

MATERIALS and TECHNICAL SPECIFICATIONS

CERTIFICATIONS

Non-sterile masks are included in the class I category, according to EEC Directive 93/42 dated June 14, 1993, relating to medical devices

Likewise, they comply with the requirements of the UNE-EN14683:2019+AC standard.

WARNINGS

• As with any other respiratory protective equipment, the user must be trained in the correct use of the equipment.
• These masks do not protect against gases, vapors, solvents from spray painting operations or oxygen-deficient atmospheres (< 19.5%).
• Use only in adequately ventilated areas that contain enough oxygen to sustain life.
• Do not use when concentrations of contaminants are immediately dangerous to health or life.
• Leave the area immediately if:

1. breathing becomes difficult
2. you feel dizzy or other discomfort

• Discard and replace the mask if it has been damaged in any way, if breathing resistance becomes excessive, or at the end of each shift.
• Masks should never be altered or modified.
• To ensure their effectiveness, masks should be discarded every 6-8 hours.

STORAGE CONDITIONS

• Store at room temperature
• Avoid excessive temperature and humidity

INSTRUCTIONS FOR USE

TO PUT ON THE MASK

1. The first thing is to wash your hands with soap and water or disinfectant gel, following the steps established by health authorities.
2. We assume that the mask is fine, but we would have to check it first to check that it has no tears or holes. To do this, it is held by the rubber bands and checked against the light. Once this is done, we could now place it.
3. Important: we must make sure that it covers us well, and adjust the upper part to the shape of our nose.

TO REMOVE THE MASK

1. To remove it you have to go to the sides and not to the center. To do this, you have to hold it again by the side rubber bands and pull it forward, making sure that it stays away from your clothing and face at all times in case there are any contaminated areas.
2. The last step is to throw it in the trash and wash your hands

SHIPPING

Product for immediate shipping. Order cannot be canceled or returned.