Flexible, thin, and cut-resistant glove level D TEGERA INFINITY 8807W

Fine cut protection glove for assembly and handling work, promoting a dry grip. This professional glove combines a 15 gg knitted fabric with a supersoft nitrile foam palm coating and reinforcement between the index finger and thumb, designed for frequent use in environments with cut risks.

FEATURES

• 15 gg knitted fabric with CRF® technology for cut resistance level D (EN ISO 13997)
• Supersoft nitrile foam palm coating for grip on dry surfaces
• Grip design with foam-like relief to improve control of small parts
• Reinforcement between the index finger and thumb to increase durability in wear areas
• Breathable materials for continuous use with less heat buildup
• Knit wrist for a stable fit and reduced dirt entry
• Contact heat protection up to 100 °C (applicable in the palm area)
• Suitable for food handling

BENEFITS OF TEGERA INFINITY 8807W FINE GLOVES

This glove helps work with sharp-edged parts and tools while maintaining good touch and hand mobility, which is common in assembly, maintenance, and material handling. The nitrile foam coating improves grip in dry conditions, and the reinforcement in the thumb area reduces wear when frequently pinching or holding components.

USES AND APPLICATIONS: WHAT JOB IS IT SUITABLE FOR

Recommended for precision assembly, installation work, use with machinery, and warehouse tasks where fine grips and handling of cut-risk parts alternate. It fits into activities in metal, glass, maintenance, logistics, automotive, and construction, especially in dry or slightly humid environments.

TECHNICAL DATA

• Coating type: coated palm
• Coating material: nitrile foam and water-based PU
• Lining material: HPPE, nylon, fiberglass thread, and elastane
• Fabric gauge: 15 gg
• Cut resistance (EN ISO 13997): level D (TDM 17 N)
• Standards: EN ISO 21420:2020; EN 388:2016+A1:2018 (4X43D); EN 407:2020 (X1XXXX)
• EPI category: Cat. II
• Contact heat protection: up to 100 °C (valid only for the palm area)
• Cuff: knitted fabric
• Sizes: 5 to 11

FREQUENTLY ASKED QUESTIONS ABOUT TEGERA INFINITY 8807W FINE GLOVES

Is it suitable for precision work or does it lose touch when handling screws and small parts?

It is aimed at assembly and fine handling tasks: the 15 gg fabric and palm coating provide good sensitivity in the fingertips, useful for picking up and positioning small parts without the hand feeling "clumsy."

What type of surfaces does it grip best: dry, wet, or oily?

The nitrile foam coating is designed to provide grip on dry surfaces. In tasks involving oils or grease, the grip behavior may change, so it's advisable to consider a specific model for oily environments if your work is primarily in such conditions.

How do I choose the size and what size range is available?

It is manufactured in sizes 5 to 11. To maintain dexterity and avoid snags, a snug fit without being tight is desirable: there should be no excess fingertip length, and the cuff should remain stable without cutting off circulation.