IRUDEK Wind 4 Pro fall protection harness

The IRUDEK Wind 4 Pro Harness is designed to provide maximum safety and comfort for work at height. Its advanced features make it the ideal choice for demanding professionals.

FEATURES

• Dorsal and frontal textile fall protection anchor: Optimal lightness and safety.
• Aluminum side rings: Precise positioning.
• K-EASY automatic buckles: Quick and secure adjustment.
• Adjustable straps: Perfect fit at height, waist, and thighs.
• Plastic protections at the ends: Greater durability.
• Textile rings on shoulders: Safe vertical evacuations.
• Textile connection rings: Uniform load distribution.
• WINDBOARD dorsal plate: Protection against abrasions.
• XPE EVA padding and RIPSTOP fabric: Comfort and resistance.
• ELDU hook holder: Automatic release.
• ANTISLIP SYSTEM: Keeps the straps in place.
• NFC Ready chip: Traceability and product review.

TECHNICAL DATA

• Weight: 2150 grs
• Usage capacity: 140 Kg
• Strap width: 44 mm
• Service life (years): 10 years of use + 2 of storage

PACKAGING DATA

Weight: 2150 grs

Units per box: 1

MATERIALS

• Strap: Polyester
• Thread: Polyamide
• Rings: Aluminum
• Automatic buckles: Steel

SIZE GUIDE

A

S-M: 45-70

L-XXL: 45-100

B

S-M: 90-130

L-XXL: 100-155

D

S-M: 150-185

L-XXL: 175-210

* Measurements expressed in centimeters

STANDARDS/REGULATIONS

EN361 I EN 358 I EN 1497

USAGE LIMITATIONS

The equipment must be assigned individually to a person.

- It is recommended that the anchorage point where the fall protection system will be fixed is above the user. The anchorage point must have a minimum static resistance of 12 kN (metal) or 18 kN (textile) and must comply with the requirements of Standard EN 795:1996 / EN 795:2012.

- Personal protective equipment should not be used by individuals whose health status may affect the safety of the user under normal use conditions or in case of emergency.

- Personal protective equipment should only be used by a trained and competent person in its safe use.

WARNING

- A fall arrest harness is the only acceptable body restraint device that can be used in a fall protection system.

- The fall protection system must only be connected to the connection points of the harness that are identified with the uppercase letter “A”. The identification “A/2” indicates that it is necessary to connect two disconnection points with the same identification at the same time. It is prohibited to connect the protection system to a single connection point identified with “A/2”.

- In harnesses with an integrated belt, the connection to the positioning work equipment must only be made to the lateral anchorage rings of the belt.

- The connection to the anchorage point and to other equipment must be made through carabiners in accordance with EN362:2004.

- For use with fall protection EN 353-1:2014+A1:2017, EN 353-2:2002, it is recommended to connect the equipment to the frontal anchorage point of the harness. For use with energy absorbers EN 355 or with fall protection EN 360, it is recommended to connect the equipment to the dorsal anchorage point of the harness. - Before each use of the personal protective equipment, it must be carefully inspected to ensure that it is in usable condition and functions correctly.

- During the pre-use check, it is necessary to carefully inspect all elements of the equipment to verify that they do not show signs of deterioration, excessive wear, corrosion, abrasions, degradation from UV radiation, or incorrect use. Pay special attention to the straps, seams, anchorage rings, buckles, and adjustment elements.