Reinforced thumb glove D cut-resistant RobustoLux CAT II (12 pairs) DIGITX

Cut-resistant gloves level D for handling pieces with edges and maintaining grip in dry, wet, or oily conditions. Seamless 13-gauge fabric with micro-foam nitrile coating and sandy finish, with reinforcement in the thumb area. Pack of 12 pairs.

FEATURES

• Cut protection level D (TDM)
• Micro-foam nitrile coating with sandy finish
• Double coating for grip in dry, wet, and oily conditions
• Seamless fabric (13-gauge) for touch and dexterity
• Sewn reinforcement in the thumb crotch for greater durability
• Extra long elastic cuff for fit and reduced dirt entry
• Mechanical resistance EN 388: 4X42D
• Presentation: 12 pairs per bag

BENEFITS OF RobustoLux Polyethylene Cut-Resistant Glove CAT. II (12 pairs)

This work glove is designed for tasks involving sharp materials where grip control is needed. The nitrile with a sandy finish helps hold pieces in dry, wet, or oily conditions, while the thumb reinforcement protects a common wear area. The seamless construction facilitates hand mobility in precision work within the range of a level D cut-resistant glove.

USES AND APPLICATIONS: WHERE IT IS SUITABLE

Suitable for handling glass, general maintenance, woodworking, sheet metal handling, waste management and recycling, and handling small pieces with sharp edges. It fits in environments where grip may be affected by moisture or oils and protection against mechanical risks is required.

TECHNICAL DATA

• Type: protective glove against mechanical risks
• Materials (support): UHMWPE (high modulus polyethylene), fiberglass, steel, polyester, and spandex
• Coating: micro-foam nitrile with sandy finish; sandy fabric sewn in the thumb area
• Gauge: 13G
• Sizes: 7, 8, 9, 10, 11
• Approximate weight: 43 g per glove (+/- 10)
• Packaging: 12 pairs per bag; 144 pairs per box
• Resistances EN 388 (marking): abrasion 4, blade cut X, tearing 4, puncture 2, TDM cut D (4X42D)

NORMS AND CERTIFICATIONS

• Regulation (EU) 2016/425 (PPE): European framework that establishes requirements for personal protective equipment; this glove is classified as PPE category II for intermediate risks.
• EN ISO 21420:2020: general requirements for gloves (design, sizing, safety, and marking), useful for ensuring correct and consistent use at work.
• EN 388:2016+A1:2018 (4X42D): evaluates resistances against mechanical risks (abrasion, blade cut, tearing, puncture) and the TDM cut level (D), guiding on the type of tasks with cut risk.
• EN 407:2020 (X1XXXXNL): evaluation against thermal risks; the marking indicates the result by sections according to the standard and serves to assess its suitability if there is exposure to heat at work.

FREQUENTLY ASKED QUESTIONS ABOUT RobustoLux Polyethylene Cut-Resistant Glove CAT. II (12 pairs)

In what type of work is the difference in grip most noticeable?

In tasks where smooth pieces or those with moisture or oil residues are handled (for example, sheet metal, metal parts, or materials under maintenance). The sandy finish of the nitrile is designed to maintain control when gripping in dry and wet conditions.

What does “cut-resistant level D” mean in daily use?

It indicates that the glove achieves a high level of cut resistance in the TDM test (ISO 13997) within the EN 388 standard. It is a practical reference for work with the risk of cuts from edges or corners, maintaining dexterity in the hand.

How do I choose the right size?

Select from sizes 7 to 11 based on your hand. If you are between two sizes, the option that fits without being tight usually helps maintain dexterity and reduce fatigue during prolonged use.