Cut protection gloves biocircular TEGERA 909V

Cut protection glove for precision work with small parts and sharp edges, featuring a PU coating on the palm and 18 gauge for greater sensitivity in the fingertips. Suitable for dry or slightly humid environments where grip and touch are needed.

FEATURES

• Polyurethane (PU) coating on palm, smooth finish
• 18 gauge for greater dexterity in fine tasks
• Cut resistance level B (EN ISO 13997)
• Good grip on dry and slightly humid surfaces
• Water and oil repellent palm
• Design oriented towards precision work
• No steel or fiberglass fibers

BENEFITS OF TEGERA 909V CUT PROTECTION GLOVES

This model is designed to reduce the risk of cuts when handling components with edges, while maintaining a high touch sensitivity for screwing, assembling, or manipulating small parts. The PU coating on the palm provides grip without adding excessive stiffness, and the 18 gauge construction promotes finger mobility in continuous precision tasks.

USES AND APPLICATIONS: WHAT WORK IS IT SUITABLE FOR

Recommended for fine assembly, maintenance, installation, and handling of sheet metal or components with sharp edges where dexterity is required. It fits well in automotive, warehouse, logistics, and workshop jobs, especially in dry or slightly humid environments where stable grip is needed when handling parts.

TECHNICAL DATA

• Coating: PU on palm (palm-dipped), smooth finish
• Support: Dyneema® (Diamond technology), nylon, and spandex
• Gauge: 18
• Cut resistance (EN ISO 13997): level B
• Glove standard: EN ISO 21420:2020
• Mechanical protection: EN 388:2016 + A1:2018 (marked 3X41B)
• EPI category: Cat. II
• Sizes: 5 to 11

REGULATIONS AND CERTIFICATIONS

• EN ISO 21420:2020: general requirements for protective gloves (sizing, ergonomics, material safety, and user information).
• EN 388:2016 + A1:2018 (3X41B): evaluates mechanical risks such as abrasion, tearing, puncture, and cut; level B indicates cut resistance measured by EN ISO 13997 in the tested area (usually the palm).

VIDEOS ABOUT TEGERA 909V CUT PROTECTION GLOVES

FREQUENTLY ASKED QUESTIONS ABOUT TEGERA 909V CUT PROTECTION GLOVES

Is it suitable for precision work with small parts?

Yes. The 18 gauge and the PU coating on the palm are designed to maintain sensitivity in the fingers and a stable grip when handling small components.

In what working conditions does it offer the best grip performance?

It is designed for use in dry and slightly humid environments, where the PU on the palm can improve control when holding parts and tools.

How do I choose the right size?

It is available in a wide range of sizes (5 to 11). To get it right, measure the circumference of your hand and compare it with the manufacturer's usual size guide; if you are in doubt between two sizes, prioritize the fit that allows you to move your fingers without excess at the tip.